- Home /
- Marine Electronics & Raymarine /
- Networking & Cables /
- SeaTalkng & NMEA 2000 /
- Raymarine E-Classic To SeaTalkNG Adapter Cable
Products
- Batteries
- Boat Hardware
- Comfort
-
Electrical
- Electrical Procured
- Battery Switch
- Busbars, Terminals & Insulators
- Cable Management
- Circuit Breakers
- Deck Seals
- Electrical Panels
- Electrolysis Protection
- Engine Instruments
- Fuses & Fuse Blocks
- Heat Shrink
- Horns
- Meters
- Plugs & Sockets
- Single & Multi-Core Cables
- Switches
- Tank Senders
- Terminals & Crimps
- Accessories, Upgrades & Spares
-
Marine Electronics & Raymarine
- Antennas
- Autopilots
- Axiom Range
- Digital Switching
- Electronic Charts
- Element Series
- Fishfinder/Sonar Modules
- Instruments
- Marine AIS Devices
- Marine Cameras
- Mounting Systems
- Networking & Cables
- NMEA Converters & Sensors
- Radar
- Satellite TV
- Thermal Cameras
- Transducers
- VHF Radios
- Accessories, Upgrades & Spares
- Marine Lighting
- Power Generation & Management
- Propulsion & Around The Engine
- Pumps
- Safety Solutions
- Sanitation & Tanks
- Steering Control & Trim
- Tenders & Inflatables
- Vessel Manoeuvring Systems
- Watermakers
- Winches & Cranes
Raymarine E-Classic To SeaTalkNG Adapter Cable
Raymarine SeaTalkng to E Series Adapter Cable 1.5M
An adapter spur cable to connect an E-series display to a SeaTalkng network, using the SeaTalk2 port on the back of the E-Series.
Note: The SeaTalk2 port on an E-Series display is not normally active. You must go into the 'System Setup' menu and then into the 'System Integration Setup Menu' and change the 'ST290 System' setting to ON. This will make the SeaTalk2 port active. Communication with a SeaTalk NG network through this adapter cable will not be possible until this change is made.